Bradford White Power Vent M-1-TW 50S6FBN, 50Gal , 40,000 BTU

The TTW®1 FVIR Defender Safety System® Models Feature:
■ Bradford White ICON System™—Intelligent gas control with spark to pilot ignition
system eliminates the constant burning pilot. This results in savings of pilot gas during
stand by periods (120 V.A.C.).
— Enhanced Performance—Proprietary algorithms provide enhanced First Hour
Delivery ratings and tighter temperature differentials.
— Advanced Temperature Control System—Microprocessor constantly monitors and
controls burner operation to maintain consistent and accurate water temperature levels.
— Intelligent Diagnostics—An exclusive green LED light prompts the installer during
start-up and provides ten different diagnostic codes to assist in troubleshooting.
— Separate Immersed Thermowell—High strength advanced polymer composite
thermowell provides isolation between electric temperature sensor and surrounding
water. No need to drain the tank when removing gas valve.
■ Compatible With Optional Accessory Packages—Performance Package, Protection
Package and Inlet Shut-Off Valve.
■ Power Vented Water Heater—Designed for installations where atmospheric units
cannot be used. Exhaust gases are vented under positive pressure directly out of the
building through the roof or the wall.
■ Powerful Blower Motor—Our significantly quiet design has greater resistance to
outside winds and the power to vent in many difficult venting situations.
■ Horizontal and Vertical Venting—With 2″ or 3″ PVC, ABS or CPVC (Maximum
equivalent vent length on reverse side).
■ Advanced ScreenLok® Technology Flame Arrestor Design—Flame arrestor is
designed to prevent ignition of flammable vapor outside of the water heater.
■ Flammable Vapor Sensor—Electronic sensor prevents burner operation if flammable
vapors are detected. The sensor will also prevent operation if there is ongoing
flammable vapor burn inside the combustion chamber.
■ Maintenance Free—No regular cleaning of air inlet openings or flame arrestor is
required under normal conditions.
■ Sight Window—Offers a view into the combustion chamber to observe the operation of
the pilot and burner.
■ Factory installed Hydrojet® Total Performance System—Cold water inlet sediment
reducing device helps prevent sediment build up in tank. This increases first hour
delivery, while minimizing temperature build up at top of tank.
■ Vitraglas® Lining—Bradford White tanks are lined with an exclusively engineered
enamel formula that provides superior tank protection from the highly corrosive effects
of hot water. This formula (Vitraglas®) is fused to the steel surface by firing at a
temperature of over 1600°F (871ºC).
■ 1″ Non-CFC Foam Insulation—Covers the sides and top, reducing the amount of heat
loss. This results in less energy consumption, improved operation efficiencies and
jacket rigidity.
■ Pedestal Base.
■ Water Connections—3/4″NPT factory installed true dielectric fittings.
■ Factory installed Heat Traps—Design incorporates a flexible disk that reduces heat
loss in piping and eliminates the potential for noise generation.
■ Protective Magnesium Rod.
■ T&P Relief Valve—Included.
■ Low Restriction Brass Drain Valve—Durable tamper proof design